Here is my write up to configure the Tactic TTX650 for crawler 4WS. This is based on my Venom Creeper.
Mode 2 Channel setup:
Channel 1 – Aileron – Rear Steer
Channel 2 – Elevator – ESC (forward/reverse)
Channel 3 – Throttle – Remote Diff
Lockers (down=locked/up=unlocked)
Channel 4 – Rudder – Front Steer
Channel 5 – AUX5 – Remote Light
Switch > Switch B (2-position switch)
Channel 6 – AUX6 – Remote Dig Unit
> Switch E (3-position switch)
Radio setup steps:
- Turn on radio and select model.
- Press ENTER to enter menu.
- Scroll down to PROGRAMMABLE MIXER and press ENTER.
- Select Mix1 and press ENTER.
- For input channel (mix left selection), press ENTER.
- Scroll through to CH4 (rudder), press ENTER.
- Scroll to output channel (mix right selection), press ENTER.
- Scroll through to CH1 (aileron), press ENTER.
- Scroll to RATE L, press ENTER.
- Change percentage to +100, press ENTER.
- Scroll to RATE R, press ENTER.
- Change percentage to +100, press ENTER.
- Scroll to INH, press ENTER.
- At prompt to “Chose the Control Switch”, moves desired switch for mix. For me, this is Switch A.
- Press ESC to exit Switch settings.
- Press ESC to exit Mix1 settings.
- Scroll down to PROGRAMMABLE MIXER and press ENTER.
- Select Mix2 and press ENTER.
- For input channel (mix left selection), press ENTER.
- Scroll through to CH4 (rudder), press ENTER.
- Scroll to output channel (mix right selection), press ENTER.
- Scroll through to CH1 (aileron), press ENTER.
- Scroll to RATE L, press ENTER.
- Change percentage to -100, press ENTER.
- Scroll to RATE R, press ENTER.
- Change percentage to -100, press ENTER.
- Scroll to INH, press ENTER.
- At prompt to “Chose the Control Switch”, moves desired switch for mix. For me, this is Switch D.
- Press ESC to exit Switch settings.
- Press ESC to exit Mix1 settings.
- Press ESC to exit PROGRAMMABLE MIXER.
- Press ESC to exit SETTINGS menu.
This setup allows the following
steering options:
- Switch A and D off (set to 0 position) = Independent control of Front and Rear steering.
- Switch A on only (set to 1 position) = Crab Crawling.
- Switch D on only (set to 1 position) = Tight steering.
With this setup I have the most control I can get with the steering. This, for me, is a massive improvement over having the 4WS modes cycle through by repeatedly pressing a button. I can near instantly access the steering mode I want to use.
No comments:
Post a Comment